Forum: BMW

I'm going to be changing my rotors and pads and was thinking of using RDA rotors and Infinity pads both of which I've used before on other vehicles with no problems. However It's come to my attention that BMWs can be little bitches when it comes to the brakes and can give endless squeeling and...

Hey guys, i have a feelin my car is running a bit rich. was just wondering what the fuel consumption of your cars are? including the year, model and engine :) this might be helpful to others too. thanks

I've just been quoted $210.00 for 5 ltrs (nothing smaller) of MTF LT-1 gearbox fluid (yellow sticker on gearbox) by good ole BMW. I need 1.215ltrs for the change I have absolutely SFA I can use the other 3.785 ltrs for so apart from the cost, which is bad enough 75% will be wasted. Does anyone...

the lights in the e28 esp and to a sertan extent the e34 are pretty poor compared to the ddm xenons in the e36. Are they upgradable, and if so what globes do they use (in foglights also). thankyou in advance for this basic but neccisary request.

i have noticed that in the USA its easy to get a set of these mats :love http://www.koperformance.com/BMW/oe_maintenance_misc/oem_bmw_floor_mats/genuine_m_z_embroidered_oem_bmw_floor_mats_z3_z4_m3_m5_e36_e39_e46.htm ...

I just put a new clutch master cylinder in my E30, and i cannot seem to get it to bleed up properly using the normal methods. I have also tried using a pressure bleeder with about 10psi, and that didn't work either. I have read that you need to reverse bleed them from the bottom up-Is that...

Hi Ladies and Gents, I have sent my car to them to get the waterpump and thermostat change today on my e36. I explained the fan delete mod thingy and they were a bit hesitant. Any of you guys got experience with them before? Are they a bmw performance workshop or just your regular run of...

Hmm ever since I let Adam tune it, the car has been sluggish, doesnt rev well... it like lags and then after 4000rpm it picks up abit and pulls to redline. Anyways I noticed before that the spring tension was soft, but now its pretty hard... Ive been mucking around with it for the past few hours...

hi all Im going to be reding the rear end soon (lsd diff, noltec subframe + trailing bushes) and i need to know what to do with this situation. ATM i have the 480,000kms shell and the 280,000kms donor. Ive got the front struts from the parts car in the shell as they were stored inside the car...

Our family car is a 2002 BMW E46 325i manual, which I really enyoy driving. My wife rang me at work to say the brake lights had come on by themselves while the car was parked in the driveway ! I thought it may be the brake switch, but then she said the brake lights go off if the car is started,...

Hey, Im doing my timing belt today and im trying to get cam gear off to change the cam seal but the bolt is on friggin tight. Im trying to loosen the bolt with the old belt on but im worried about it skipping teeth and rooting a valve. I've got a breaker bar on it and am pulling as hard as i can...